Welcome! Log In Create A New Profile

Advanced
Call/Select Dimmers for Stage setup
April 19, 2019 03:27PM
Hey alltogether,

for a big show I prepared a LC24/6 Extension Desk with all Dimmers for my operator there to remote GMA2. Now I', trying to find a routine/write a macro to enable him to quickly step through single channels of these stored Executors (e.g Full stage: ch 55-65+78-81) with "Next" in Highlite and Solo mode without
having to input the channels again, which he doesn't know. I tried "Call" + wanted Executor and after that SelFix + wanted Executor which I thought should bring the stored channels to the programmer and select them. Tapping "Next" after that always just brings up the whole set, not the single channels.
What's a good routine here for setting up stage with single channels based on stored executors?

THX a lot
Subject Author Posted
Call/Select Dimmers for Stage setup MF-VT April 19, 2019 03:27PM
Re: Call/Select Dimmers for Stage setup scoobytoobins April 20, 2019 12:51AM
Re: Call/Select Dimmers for Stage setup glad April 20, 2019 01:24AM
Re: Call/Select Dimmers for Stage setup MF-VT April 21, 2019 03:55PM



Sorry, only registered users may post in this forum.

Click here to login