well, it seems this isn't what's described in your original post either. do you want the delay to go from center out on when the lights come on, then from outer to the center when the lights go off? if yes, your selection order is wrong.
if this is the order that you want, then you should also share the settings of the executor that you claim is not working properly for you, since that would be the other issue here.
if you take your fixtures, put them at full, store delay 0 thru 1 in cue 1
then put them at 0, release, whatever you want, store delay 1 thru 0 in cue 2
and set cue 2 to follow
this will definitely work.
if you then also set cue 1 to follow, this will loop indefinitely until you off the executor.
Kai Colucci
VX / LX programmer
Miami, FL