Welcome! Log In Create A New Profile

Advanced
strange behavior of programmer and dimmer wheel
March 19, 2021 09:40PM
Hello,

I’m stuck with some strange behavior of programmer and dimmer-wheel after changing some macros.
Putting dimmer values in the programmer (Fixture thru at Full) gives no output, value layer shows 255, output layer 0. Touching the dimmer wheel an turning it only one step (also down) brings all Fixtures to full an they can now be controlled via dimmer-wheel; clearing out the programmer leaves fixtures at the level set by dimmer-wheel although they are not even selected and the programmer is empty.
This happens also when the predefined macro „Set Running Show Status“ is used, so no problem with Highlite, Solo, Grandmaster...

Maybe I entered a command accidently while programming. What do I miss here? I use onPC 3.7.0.3.

Thanks for any idea.
Subject Author Posted
strange behavior of programmer and dimmer wheel MF-VT March 19, 2021 09:40PM
Re: strange behavior of programmer and dimmer wheel Ryan Kanarek March 19, 2021 10:18PM



Sorry, only registered users may post in this forum.

Click here to login