I already tried the first time to update it with the "2Port SW Update" key but it did nothing at all... Anyway i could finally update the firmware by connecting it with a real MA2 console. I don't know if there is a way to do it through On PC, but i couldn't find it, so using an MA2 Console worked for me :) Thanks a lot for your suggestions!by danisinmas - grandMA2 discussion forum
Ok! So i finally could update the firmware, and had to do it through a real MA2 console, i was unable to do it through On Pc. I didn't have a switch to try it the way you suggested so i don't know if it would've made any difference. Anyway it's working just fine now! :) Thanks for your help!by danisinmas - grandMA2 discussion forum
Hi Michael! Yes i can ping the Node and communication is fine. Good speed, no packages lost. I tried the following: - Disconnected ethernet wire form the station - Pressed the menu button of the Node with power off and turned it on with the button pressed. - The Node goes into "Update Client" mode. - In this mode, On PC finally detects the Node and i can see it in the netwby danisinmas - grandMA2 discussion forum
Yes it's there, but the problem is that the On Pc doesn't detect that there's a Node connected to the session and the update button is disabled..by danisinmas - grandMA2 discussion forum
Ethernet cable is straight btw, T568B bothby danisinmas - grandMA2 discussion forum
Hi Pago! You're right, the firmware is out of date. But how can i update the firmware without connecting to the node?by danisinmas - grandMA2 discussion forum
Hi! Regarding your suggestions: 1. Not using a wired connection for all stations/nodes (e.g. connecting a laptop to the network via WLAN) Only network connection is PC to Node via CAT6 wire. I even disabled any other network connections (Wifi) 2. having the same IP-range on several network-adapters on one station (e.g. both WLAN and LAN starts with 192.168 etc) Didn't know that, and for a mby danisinmas - grandMA2 discussion forum
Hi glad! The 3D is on the same computer. I could maybe try to connect 3D from a different computer on the same network see if there's any troubleby danisinmas - grandMA2 discussion forum
Hi! I am using an MA 2Port Node On PC Pro.by danisinmas - grandMA2 discussion forum
Hi! I've been tryin to connect a 2Port Node to On PC but it doesn't seem to work. I've checked IP adress of the Node (192.168.0.137) and i've set the IP on my PC to the same range (192.168.0.10). I've created a session with that IP, and both On PC and the Node have the same session IP (1). The session end is fine, i can connect MA3D with no issue. But when i try to "add present" toby danisinmas - grandMA2 discussion forum