Hi Michael!
Yes i can ping the Node and communication is fine. Good speed, no packages lost.
I tried the following:
- Disconnected ethernet wire form the station
- Pressed the menu button of the Node with power off and turned it on with the button pressed.
- The Node goes into "Update Client" mode.
- In this mode, On PC finally detects the Node and i can see it in the network config window, but "2 port SW Update" button does nothing at all...
- On the other hand, in the software update window, the node doesn't show, as if it's still not connected, so i cannot update it from there...
I've seen this comment about a similar problem in another froum:
"I also had a similar problem a while ago, a stuck 2port node. As far as i recall the solution was to use a real console (gma light) to update and acess the 2Port node. Only when connected to the onPc it did not work."
Maybe that is the only way...